Checkpoint LAB USB-RS232 Guía de usuario descargar pdf (Pagina 17)

©Microcontroller-café & Checkpoint LAB M35160 ERASER/PROGRAMMER User’s Guide

5 Troubleshooting Guide start

To avoid most comment problems to using the tool please follow to the recommendations:

NOTE: Save original data from M35160/D160D0WQ/D80D0WQ/M35080 to a file, before

making any changes . Use “READ 160” or "READ 080" function to save data to a binary file.

Before to make any changes, such as writing a lower value to the incremental registers of a

target memory make sure that incremental area erased, if no execute “WRINC” command.

----------------------------------------------------------------------------------------------------------------

◆ Problem:

The Led3 is not ON.

◆ Reason:

DC cable is broken or wrong power supply (or wrong polarity) is used

◆ Solution:

Check cable and connect the DC power cable to the DC jack or check that the power

supply source is DC type 10-15 V, min. 500 mA

-------------------------------------------------------------------------------------------------------------------

◆ Problem:

Programmer do not recognize a serial port

Figure 19

◆ Reason:

Serial port dot not exist

◆ Solution:

Select appropriate serial port

-------------------------------------------------------------------------------------------------------------------

◆ Problem:

Led 2 endless blinking AU mode / PC mode

◆ Reason:

Target memory M3510/D160D0WQ/D080D0WQ/M35080 error (not erased)

◆ Solution:

Pay attention to first pin orientation target IC into the target socket,

short circuits on the programming adapter, then try again

-------------------------------------------------------------------------------------------------------------------

◆ Problem:

Numeric display message

“ EE“

◆ Reason:

Target memory M3510/D160D0WQ/D080D0WQ/M35080 error (not erased)

◆ Solution:

Pay attention to first pin orientation target IC into the target socket,

short circuits on the programming adapter, then try again

1 2 ... 12 13 14 15 16 17 18

Sin comentarios

Checkpoint LAB USB-RS232 Guía de usuario Pagina 17